Showing posts with label an2135sc. Show all posts
Showing posts with label an2135sc. Show all posts
Saturday, February 11, 2017
Renault Can Clip 1 1 clone of the original with AN2135SC Chip
Renault Can Clip 1 1 clone of the original with AN2135SC Chip
This is the newest Renault Can Clip diagnostic interface, based on the other versions and improved a lot with the AN2135SC chip. Now Can Clip v163 china is a 1 to 1 clone of the original.
Quality A+++ Can Clip for Renault because of the AN2135SC chip.
In the PCB, engineers add the high quality chip CYPRESS AN2135SC or CYPRESS AN2136SC.
The new chip AN2135SC/AN2136SC solved communication issues of old CLIP (esp. the most populous version sp19-b). That make CLIP work more stable and can be used for a longer time
Using other versions of Renault CLIP, the diagnostic interface will disconnect if users have no operation for 10 minutes around after successful communication to the car.
With this new CAN CLIP for Renault, the issue solved, with the chip AN2135SC/AN2136SC. This is the PCB with new design.
So that it can works no issues as the original.
Professional engineers at diyobd2 have verify the new Renault CAN CLIP v163 work ok on almost systems like ENGINE, automatic gear shifting, Air conditioning system, SRS, ABS, ASR, MPL, GM, IMMO, KEYZESS GO system, OBD-II and so on
Work ok both on Windows XP and Windows 7
Test on basic diagnostics and reprogramming... Incl:
- See all the information relating to the vehicle
- Computer test
- Automatic test of all computers
- Airbag test
- Ccantool (OBD tests)
- Base Doc (access to Technical Notes)
- Physical measurements
- Antipollution
- Multimeter
Original - from diyobd2.fr OBD2 service technique:Renault Can Clip 1:1 clone of the original with AN2135SC Chip
Available link for download
Monday, January 23, 2017
Renault CAN CLiP no vcc 3 3v to AN2135SC customer solution
Renault CAN CLiP no vcc 3 3v to AN2135SC customer solution
In the Renault CAN CLIP inner board, I found no vcc 3.3v to AN2135SC fromvoltage regulator. Actually there is no +5v IN from usb port to voltage regulator . Need +5v on both pins (1 and 3)
On red arrow no +5V on image,normally no 3v3 to blue arrow,but on green there is +5v
Also from back side near usb connis also same vol.reg and its have all voltages ok
Also from back side near usb connis also same vol.reg and its have all voltages ok
Here are some Renault clip users’ solution. I adopted it... Worked!
it is possible solder a wire from +5v to IN pin, but also need to OFFON pin to enable output voltage 3.3v. But in that case both red diodes are ON even no connected obd conn to car. Also tried to "take" 3.3v from other clip pcb and then find sonde when start clip sq, only ask for firmware update so will try lower version sw. Now use v96
Then I sill bring +5v to both IN and ON/OFF and will get 3v3 only both red leds will be on
Another user also had a problem with the 3.3V regulator , and he used a normal 3.3v regulator without ON/OFF and it worked correctly , except that the 2 red leds always on.
Original:Renault CAN CLiP no vcc 3.3v to AN2135SC (customer solution)
Available link for download
Subscribe to:
Posts (Atom)