SEMEURBAK

DigiProg is the worldwide leader in the production and marketing of digital speedo programming and correction software. Now the newest version is v5.85. It can support Alfa, Aston Martin, Audi, Bentley, BMW, Cagiva Raptor, Chevrolet, Chrysler, Citreon,Daimler Benz, Dodge, Ferrari, Fiat, Ford, GM, Honda, Hyundai, Jaguar, Kia etc.

Now here are some steps which can tell you how to set up the Digiprog III:

1) You need to power your Digiprog with a regulated 12V power, it might be got damaged if the power is above 13.5V, the main circuit board will get burned, and then you need to sent your Digiprog to your supplier for repairing.

2) Pleasd don’t use the cigar lighter lead when connect it to a vehicle by OBD, and it takes power from the vehicle. It will not be covered in the warranty if you do not observe.

3) When your Digiprog is power on, the screen will show like this as below:

4) You can see the software and serial number on this interface.
5) It will comes out a disclaimer regarding the use of the machine when finish loading.
6) Please press the check/tick button while it is ready.

7)You need to type a password to enter to use the Digiprog III, and the password is “1?.

After all these have been done, you can use the Digiprog 3 v4.94 now.

Here are some instructions of updating:

Plesas advise your serial number before sending update application, so that we can offer proper software programmer for you.

1)Please connect the USB to your computer, and then run the Digiloader1.exe with your Digiprog.
2)Choose the right port and select the Digi1.bin, click the button. Please restart the step 1 if your Digiprog III does not go to blue screen.
3)It is upgrading now, please keep this states till over, and it will be damaged if you remove or restart it.
4)Updating over, your Digiprog III will restart automatically, after this you can use the updated version.

Have got the alliance vi to work with Consult3 plus software. And make Consult III+ to run it with Ford VCM II interface.

CarDaq
Actica Passthru+ XS
Python1B
Nissan USB Diag
Alliance VI
And The obvious tool VI2

all these are the best to work with Consult 3 plus.

others will also work but maybe not as well.

The Ignition ON its not seen if you use VCM II
I use AVDI and Ignition ON it is not seen too
I read that no matter what j2534 tool you use the Ignition ON its not seen
Probably, only if use Alliance VI2, but alliance vi is quite a bit more complicated to set up

Here is thesetup of VCM II with Nissan Consult 3+.

For ford VCMII
In the Diagnostictool.ini put Ford-VCM-II
Install the consult 3 plus
Install your VCMII Manager and drivers.
In passthru 4.04 in reg edit and rename NISSAN_VI2 To something else
change name Bosch Ford-VCM-II to NISSAN_VI2
Reboot computer and test it

I tested it once with limited success.

https://mega.nz/#!5kMm2TwI!1m7PLJEx_DM_ll3a1UBWuG4ZviRlSyH80iKvJN0-BLk

The sonde alliance vi is the end for the sonde can clip RTL. remplaced by sonde alliance vi but what is it.

Renault Aliance VCI = 100% Same with Nissan Consult III VCI...
Just & ONLY different name...